Teflex for metal is meant for protection against corrosion and internal sanitization of surfaces of pipes (pipelines).

Type: water disinfectant for pipes and metal surfaces with cleaning and anti-corrosive effect (concentrate)
Purpose: For killing microbes and reducing rust on internal surfaces of pipes, including drinking water supplies. For protection against all deposits and scaling within hot and cold water supply systems, such as heating.

Application on surfaces for other purposes should be coordinated with the manufacturer.
Properties: Strong adhesion. Not affected by weather conditions. Can be used as an anti-corrosive primer for iron and steel.

Structure: Modified complex of Guanidine, non-ionic surfactants, anticorrosive additives, solvent=water.
Appearance – colour= a homogenous, transparent liquid, may contain deposits.
pH 6-7
Density = about 1.1 g/cm³
Packing: 0.33l , 1l, 3l, 5l, 10l
Colour = transparent/yellowish

Safety precautions: Keep away from children. Do not inhale. Avoid contact with eyes and skin. More detailed information can be found on the MSDS sheet.
Storage: The bottle should be kept airtight. Period of storage = no more than 3 years.
Waste disposal: Dispose of as normal household waste. Do not pour down drain or into natural water courses.

Application Guidelines
Substrates: iron/steel. The substrate should be clean.
Preparation of substrate: remove all visible rust using metal brush or pressure hose
Internal surface of pipes: fill with a water solution Teflex 1:19 Water and allow to stand for 24 hours at a temperature of 50-60 degrees Celsius. On closed systems (eg central heating), it is permissible to pump the solution round for 5-6 hours. The discharged solution may be re-used as required-by filtering and then adding 10% concentrate. After this process, dry the pipes in air at about 60-80 degrees Celsius.
Processing: Teflex for metal can be applied by brush or by spraying (working solution ratio 1:19). Leave on surface for 24 hours, then rinse off with water.

Quantities: 80-110ml per m². Minimum quantity for optimal protection is 250ml per m²
Processing Temperature: Should be between 15-60 degrees. Drying 20 degrees Celcius. Partial drying occurs at 45 minutes for the first layer. 2nd layer approximately after three hours. Full polymerisation after 5 hours.
Consultations: We can answer any questions regarding this technology and would advise you to contact us.